{{ui.blackBar}}
FREE SHIPPING*Orders of $200 or more qualify. Free shipping applies to most products. Front doors, interior jammed doors & custom orders have shipping costs which are calculated at checkout.

Double X Door Assembly Instructions

Double X Door Assembly Instructions & Video

PDF instructions for this Door set are also available.

Double X Door Recommended Tools
  • Drill Phillips Bit
  • Socket Wrench with 7/16" Socket

Double X Door Parts
  • A1 L - Left Side Stile QTY: 1
  • A1 R - Right Side Stile QTY: 1
  • A2 - Bottom Rail QTY: 1
  • A3 - Middle Rail QTY: 1
  • A4 - Top Rail QTY: 1
  • A5, A6, A7 - Upper Diagonal Rails QTY: 1 each
  • B5, B6, B7 - Lower Diagonal Rails QTY: 1
  • B1, C1 - Left Edge Slats QTY: 1 each
  • B3, C3 - Right Edge Slats QTY: 1 each
  • B2, B3 - Upper Tongue & Groove Slats QTY: 6 each**
  • C2, C3 - Lower Tongue & Groove Slats Slat QTY: 6 each**
  • D1 - 6” Lag Bolts QTY: 6**
  • E1 - 1-1/4” Grabber Screws QTY: Varies**
  • E1 - 1-1/4” Grabber Screws QTY: Varies**
  • ** Can Vary Depending on Door Size

Double X Door Assembly Instructions & Video

NOTE: The following should be a ‘dry’ assembly. Do not use adhesives in when putting this door together.

NOTE: This door model comes in various sizes. The instructions have been written for the average single door size; but larger doors may have more wood and fastener parts.

Lay out all Door parts as shown here. Slide bottom rail A2 so it’s right slat goes into the groove on A1R (stile).

Slide B1, B2, and B3 slats’ tongues into A1R and A2 grooves.

Slide all remaining B slats into place. Now slide A3 Middle Rail down the A1 R grooves until it rests on the B Slats. Attach using a 6” Lag Bolt, making sure it is going straight into the predrilled hole, not at an angle. If necessary, have someone help you hold all slats and rails in place while you are fastening the Lag Bolts.

Slide all C Slats into A1 R and A3 grooves. Once all of the slats have been positioned, place the A4 Top Rail onto the C slats and in the A1 R grooves. Fasten A4 into place with a Lag Bolt, first with your hand, then tighten with a ratchet. Be sure the Lag Bolt is going straight in and not at an angle. Fasten by hand, then with a ratchet.

Slide Side Stile A1 L into place, attaching with 6” Lag Bolts, tightening by hand. Once you have determined all are in place straight, tighten Lag Bolts with a ratchet.

When the Door is assembled, place A5, A6 and A7 (Top Diagonal Rails) onto the door so the predrilled holes are facing up and so they form an X that runs from corner to corner. Attach using the 1-1/4” Grabber Screws and a drill with a Phillips bit. Your Door is ready to hang. Repeat for B5, B6, and B7 (Lower Diagonal Rails).

Get News & Special Offers
You've already subscribed to our list!Sorry, looks like your address is incomplete.Get ready to be inspired!
Hi {{storage.distributor.name}} Discounts Applied · Logout
Hide
Wish List
My Wishlist