NOTE: If you are installing a Floor Mount Door Guide, your door will have a mortise (a groove that runs along the bottom of your door). Make sure this mortise is facing down towards your floor and that you install the Door Hangers on the other end.
NOTE: The following should be a ‘dry’ assembly. Do not use adhesives in when putting this door together.
NOTE: This door model comes in various sizes. The instructions have been written for the average single door size; but larger doors may have more wood and fastener parts.
Slide A2 over so its tongue inserts into A1R’s groove.
Slide B1, B2, and B3 slats to the right and down so their tongues go into A1 R and A2’s grooves.
Slide all remaining B slats into place. Now slide A3 Middle Rail down so the groove along the bottom covers the tops of the B Slats.
. Slide all C Slats into A1 R Stile and A3’s top groove. Once all of the slats have been positioned, place the A4 Top Rail onto the C slats and in the A1 R grooves.
SUGGESTION: At this point it will be helpful to have someone help by holding your stiles, slats and rails firmly in place while you are installing the Lag Bolts.
Slide Side Stile A1 L into place. You can now install the 6” Lag Bolts, making sure your door remains straight. Tighten by hand, and if all slats are correctly in place, tighten with a ratchet with a 7/16” socket.
When the Door is assembled, place A5, A6 and A7 (Diagonal Rails) onto the door so the predrilled holes are facing up and so they form an X that runs from corner to corner. Attach using the 1-1/4” Grabber Screws and a drill with a Phillips bit. Install a Door Pull and your Door is ready to hang.