Anti-Jump Guides & Blocks Assembly Instructions

Anti-Jump Guide Installation

Step 1: Place the Anti-Jump bracket on the door side, moving the bracket up until it is between 1/8” and 1/16” from the bottom edge of the rail. Mark the placement with a pencil.

Suggestion: Use double stick tape on the back of the anti-jump bracket to hold it in place on the door.

Step 2: Install the bracket to the door edge with 2 phillips screws (provided) using a drill with a phillips bit (Figure 1).

Step 3: Repeat steps 1 and 2 for the opposite end of the door.

Anti-Jump Block Installation for bi-parting doors

Step 4: Place the Anti-Jump block on the top of the door (Figure 2). Using a drill with a phllips bit, install the the block with the 1” phillips screw (provided).

Suggestion: Use double stick tape on the back of the anti-jump block to hold it in place on the door

Step 5: Repeat step 4 for the opposite end of the door.